Chuck Ciaffone wrote:
> Yup, did it again!
>
> When I removed the distributor and plug wires, I made a
> small drawing of which wires went to which plugs. Now that
> I am reassembling the thing, I find that the wire I marked
> as going to plug #1 won't reach! And of course, nowhere in
> Haynes can I find a picture showing which posts on the cap
> are for which cylinders. (What a waste.)
>
> I'm hoping that in my eagerness to take the engine out, I
> numbered from the back rather than the front, or I mismarked
> the #1 post.
>
> Can someone PLEASE tell me, on my 1275, which post on the
> distributor cap goes to #1 and the front of the engine?
>
> Chuck
I think you are looking for a simple answer here.
#1 plug wire is on the right side of the coil wire on the lower holes.
This is for a side entry cap.
3 holes on top, 2 on bottom, coil in center hole on top, #2 is right of
coil, #4 is left of coil,
#1 right of coil lower, and #3 left of coil lower.
If I could draw I could make it look simpler.
Again #1 would be the first hole just left of the "U" shaped notch
looking down on the cap from the outside.
Hope this helps.
--
Frank Clarici
Too many Sprites
http://www.exit109.com/~spritenut
|