spitfires
[Top] [All Lists]

Re: [Spits] Spitfire 1500 differential

To: "'Roger Elliott'" <elliottr@rmi.net>, <spitfires@autox.team.net>
Subject: Re: [Spits] Spitfire 1500 differential
From: "Daniel Parrott" <parrotthead01@comcast.net>
Date: Fri, 30 Oct 2009 09:14:15 -0400
I only found 6 bushings when I rebuilt my rear spring, so I'm not sure where
the other 2 belong.  

The other place for lithium grease would be between the leaves in the center
where the spring leaves all are compressed together by the main bolt.


Dan Parrott
Savannah, Ga
1980 Triumph Spitfire "PJ"
1972/1978 Spit Six Project car "Joseph"



-----Original Message-----
From: spitfires-bounces@autox.team.net
[mailto:spitfires-bounces@autox.team.net] On Behalf Of Roger Elliott
Sent: Thursday, October 29, 2009 8:40 PM
To: spitfires@autox.team.net
Subject: Re: [Spits] Spitfire 1500 differential

Hi Everyone,

I wanted to let everyone know I got the bolt out.  It was easier than I 
expected.  I did manage to find an almost straight shot  at the bolt to 
hit  it with a drift.  There was a brake line junction that was in a 
direct line with the bolt.  Once I got the bolt started by hammering on 
it I was able to pry it out.

Thanks every one for the advice!

Now I have new questions. 

I am replacing the bushings\spacers in the leaf spring. According to 
what I have read there are 8 of them.  I have only found 6 in the 
spring.  I did not find any between the 2 longest springs which is where 
it seems there should be some.  Should mine have had them there?

Also, the Haynes manual indicates that the leaves should be lubricated 
with graphite grease.  The only graphite lubricant I can find is what 
you use for locks.  So I was planning on using Lithium grease.  Does 
that make sense?  Also where would I grease it, it seems the main points 
of contact are the bushings?

Thanks,

Roger Elliott


Roger Elliott wrote:
>
>
> I have the differential almost removed.  But I have run into a 
> problem.  I can't get the long bolt that runs through the rear mounts 
> out.  I have the nut off, but I can't get the bolt to budge.  I can't 
> figure out a way to get any leverage on it.  The end of the bolt is 
> pointed so even if I could get to the end any punch I have would slide 
> off when I hit it with a hammer.  Of course there is no straight shot 
> at it any way.
>
> Any suggestions on how to get that bolt out?
>
> Thanks,
> Roger Elliott
> _
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires

http://www.team.net/archive
_______________________________________________

Support Team.Net  http://www.team.net/donate.html


Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>