Yes, to replace the bearing you'll need an hydraulic press and a strong
plate or else you'll bend the flange if the plate does not really curve
around the shaft as you push the bearings on and off the shaft. Guess
how I know!
Alan
Bob Harris wrote:
>Jeff,
> I hope you can disassemble and find the clip that holds the bearing
>in place on the stub shaft. I have changed these brg's and found it quite
>difficult to remove the brg. from the shaft. While you're at it, there
>couldn't be a better time to replace the seal.
>
> Good Luck,
> Bob Harris
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|