I have a metal bench and I put an oak board scrap on the bench and slam the
rear end of the master cylinder on the board until it pops out the back
enough to grab it with pliers.
----- Original Message -----
From: "Dave Willner" <dwillner@icontech.com>
To: "Triumphs" <Triumphs@autox.team.net>; "spitfires"
<spitfires@autox.team.net>
Sent: Thursday, December 19, 2002 3:06 PM
Subject: Clutch salve cylinder help
> I've got the Spit's slave clinder on my bench for a rebuild and can't get
the
> piston to slide out. It slides freely in the cylinder but doesn't come out
> entirely. Any thoughts on this, the rounded metal end cap is still in
place, I
> didn't see how this would affectthe removal?, mnaybe I'm wrong..... TIA
>
> Dave Willner
> 59 TR3A Apple Green
> 80 Spitfire Carmine Red
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|