spitfires
[Top] [All Lists]

Weber DGAV setup and results

To: "'spitfires@autox.team.net'" <spitfires@autox.team.net>
Subject: Weber DGAV setup and results
From: "Bowen, Patrick" <pbowen@intellinetics.com>
Date: Sat, 16 Feb 2002 21:41:04 -0500
Well, I broke down and set up the carb.  Tuning it wasn't so hard as was
getting the electric choke set right.  I think I have it set right,  It is
running good right at about 1100 rpm.

The one thing I can't figure out, and was hoping others with this carb could
help.  Where in the devil can you hook up the electric connection for the
choke?  Looking for a place that is only hot when the engine is running, or
if that fails, a place that is hot when the key is on.

The only thing I can find on that side of the engine is one of the wires
running out of the wiper motor.  Only other items are the solenoid, and
those are either always hot, or only 6v when the key is on.  Best ideas??

Patrick Bowen* Confidentiality Notice * The information in this
e-mail/facsimile transmission is intended by intellinetics, Inc. for use
only by the individual or entity to which it is addressed.  This message may
contain information that is privileged or confidential.  If you are not the
intended recipient, you are hereby notified that any dissemination,
distribution or copy of this e-mail/facsimile is strictly prohibited.  If
you have received this transmission in error, please delete it from your
system without copying or forwarding it, and notify the sender of the error
by reply e-mail or by calling 614-921-8170.  Thank You * intellinetics, Inc.
* 2190 Dividend Drive * Columbus, OH  43228 * Phone: (614) 921-8170 *
www.intellinetics.com * Fax: (614) 850-2789

///  spitfires@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool


<Prev in Thread] Current Thread [Next in Thread>
  • Weber DGAV setup and results, Bowen, Patrick <=