Hi folks, here is a question to ponder over........I have two heads..........
those of you at the back can stop sniggering...thank you.........as I said I
have two heads and the one that came off the block I am going to use has very
bad exhaust seats so they will need replacing, is it wise to replace just the
exhaust or the inlet too (they are not too bad). The other head I have has
reasonable seats all round but the numbers differ slightly on the
head...hence my question can i interchange the heads ? Below are the
corresponding numbers
Head No1 (the original) Head No2
515973 stamped on head 515573 stamped on
head
E98 in raised letters done at casting E70 ? or E79 ?
307871 Stanpart number 307871 The same
Stanpart number
After writing all this I hope I have given enough info
Happy Spitting ...............John
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
|