Brad;
3M makes a spray-on glue for installing/repairing headliners. Auto parts
stores and many hardware stores carry it. It comes in a LARGE spray can and
you could probably do three cars with one can. I used it to fasten the heat
shield material to the bottom side of the hood (bonnet).
Reid
'79 Spitfire (original owner)
-----Original Message-----
From: Bradley D Richardson [mailto:bradrichardson@juno.com]
Sent: Tuesday, August 08, 2000 9:28 AM
To: spitfires@autox.team.net
Subject: adhesive
Ok, I'm finally going to put the seat covers back on my Spit's seats.
What adhesive should I use? Since it's form fitting, and since it was
glued to the foam before I removed them, it's obvious I need some kind of
glue. I tried contact cement, it doesn't hold at all to the foam.
On another thought, the headliner in my daily driver is drooping?
Obviously, it needs to be glued again also. Other than removing the
entire stinking headliner, is there some kind of gizmo that will let me
shoot the glue thru a small 'pin hole' in the liner?
Brad
====================================================
Brad Richardson
Portland, Oregon
79 Spitfire (FM90541U, really a 78 as made June 78)
79 Spitfire (TFZDW29T001453, really a 80 as made Nov 79)
________________________________________________________________
http://dl.www.juno.com/get/tagj.
|