Both of mine have OD, but I have no trouble getting the entire trans
removed with the car on jackstands. You should be able to put the car
up and lift the trans at the rear far enough to remove the mounts.
Mike
"D.T.Gebhard" wrote:
>
> Spitlisters:
> My rear engine mounts are shot. 1977 Spit. no
> O/D. Does anyone have a procedure or ideas to replace
> them. Is this a job that should be done by a garage
> with a lift. Just using jack stands does not give
> enough room to operate.
> Another question: I replaced my speedo cable and
> sleeve thing this past winter. Went for a short drive
> and it quit after 1.4 miles. Is it possible to have not
> installed it right??
> Thanks
> Dave Gebhard
> 1977 Spit with a sagging (engine) rear
|