To test the valve just apply 12v across the two terminals at the top of the
valve. I did this by taking two wires and touching them to the battery
terminals then to the terminals on the top of the valve. You will be able
to hear the valve move when you apply the voltage then move again when your
remove the voltage.
Bob Bollinger
79 Spit
-----------------------------------------------------------
Date: Sun, 13 Feb 2000 10:36:23 EST
From: RIBJEN@aol.com
Subject: Anti Run-On Valve
Hi Listers ,
I have an old Anti run-on valve which I want to install. Before I install
it
I have a couple of questions:
1) is there a way to test the valve to see if it is even going to work?
2) my wiring is set up for the oil pressure switch with the 3 wires. I have
an oil pressure guage and no switch so I need to buy a new switch - my
question is which wires go where on the oil pressure switch?
Thanks in advance
Bob Berger
78 Spitfire - FM76001U
|