joe, right you are about sandwich type and i probably already know why you
mentioned
tying off the hoses. yes, as a matter of fact we do offer alternatives. we
can
supply a take off, remote filter and cooler with fittings. you can either use
steelbraid orubber high pressure hose. we can also give you extra oil (and oil
cooling) capacity without going to a cooler. end of commercial. please
contact us
for details. ted
Joe Curry wrote:
> Ted Schumacher wrote:
> >
> > ok, here's my $.02 worh. first on the coolers. a cooler used to
>compensate
> > for an internal engine problem or a cooling system problem is not
>beneficial,
> > it's a bandaid. if all systems are good and you really have a high oil temp
> > (drive the car hard for a few miles and immediately pull the filter and
>stick a
> > thermometer into the filter for oil temp) install a cooler. we sell
>coolers and
> > lines but do not sell a pre-plumbed "kit" the kit forces you to put the
>cooler
> > where somebody else deciced it needed to be. also we caustion against
>using the
> > "sandwich" type cooler take-off that fits between the block adn the filter.
>this
> > puts the filter too close to the suspension upright and forces you to use a
> > small filter.
>
> I'll second that! However, it is difficult to find any other type being
> sold by the "major" suppliers. I'll bet you can tell us where we can
> get a different type! If you do use the sandwiched type, be
> absolutely sure that the hoses are securely tied away from the steering
> coupler. Otherwise the coupler will chafe through the hose and the oil
> comes out that place in a big hurry! (Don't ask how I know).
>
> a 10 row cooler is more than adequate for a street driven car
> > even with perfomrance engine mods. DO NOT BUY A USED OIL COOLER!!!!!
>since it
> > is not possible to clean out a cooler completely - it's aluminum and cannot
>be
> > "boiled" as you would boil a cast iron block - if the cooler had ever been
>on an
> > engine that had a blowup (bad rod bearing, broken piston, etc) the
>particles are
> > resting in the bottom of the cooler. the oil flow carries these particles
>in
> > suspension. when the engine was shut down, the particles fall to the bottom
>of
> > the cooler. rebuild the engine, start up and presto, the oil picks up the
> > particles adn there goes the engine. remeber you are working with bearing
> > clearances in the .0015" to .002" category. one .003" particle of aluminum
>will
> > wipe out a bearing.
> > early spits had a "windage tray stock. this was a piece of fine screen for
>lack
> > of a better description that filled the area over the deep portion of the
>pan.
> > windage trays keep the oil from splashing up so the throws of the crankshaft
> > will go through these sprays of oil this robs power. example, for $16 you
>can
> > buy a windage tray for a big block dodge. installation gives 12 hp increase
>on a
> > dyno just because the crank does not encounter the drag of fighting its way
> > through the oil spray. remeber, the engine becomes an air pum in the oil pan
> > from the force of the pistons moving down and pushing a volume of air into
>the
> > pan. very similar to being is a subway statiion andyou can feel the air
> > arriving before you see the train. ted
>
> Very good assessment Ted!
>
> Joe
>
> --
> "If you can't excel with talent, triumph with effort."
> -- Dave Weinbaum in National Enquirer
|