Bob, Iâ??d put my $$ on the master cylinder being bad. Is it new or rebuilt? Is
it possible that the master has been on the shelf for years & the seals are
dried/cracked? What kind of fluid did you use? If it is a silicone based fluid
there may be some bubbles gettin into the master.
Peace,
Pat
Pat Horne
We support Habitat for Humanity
> On Oct 9, 2019, at 5:26 PM, Robert Nogueirao via Shop-talk
> <shop-talk@autox.team.net> wrote:
>

I have a hydraulic clutch, Girling 5/8â?? master and a internal slave that
fits over the input shaft. Both are new. Problem is I have a really good
feeling petal, no leaks and good operation 90% of the time but occasionally
when you depress the clutch to change gears the petal feels soft and will not
fully release the clutch. Letting the petal out and again depressing it and the
feel and release are again normal. Reservoir shows no lost of fluid.
Since the slave is mounted on the input shaft and operates directly on the
throw out bearing there is no linkage to cause the problem.
Any suggestions as to what could be causing this problem?
Bob Nogueira
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/patintexas@icloud.com
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/pipermail/shop-talk http://autox.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/mharc@autox.team.net
|