On Thu, Nov 24, 2011 at 10:19 AM, <eric at megageek.com> wrote:
> I'm not sure if a wood working question is appropriate here, so let me
> know if I'm stepping outside the allowed content.
You'll be using a power tool in your shop, right?
> Does anyone know how to cut/expand one of those slots in a block of wood.
> I need to go about 7" deep?
How about a drill? McMaster-Carr, for instance, has many long-length,
small diameter drills. Their # 2986A51 is a 1/8" by 12" drill...you
would need to draw it out and clear it every inch or so, But I would
think that you could carefully drill a hole (or row of holes) right
next to the end of the slot and then somehow clear the remaining
material with a sharp object - maybe even the knife that will fit the
hole?
|