shop-talk
[Top] [All Lists]

[Shop-talk] Pulsing brakes

Subject: [Shop-talk] Pulsing brakes
From: wmc_st at xxiii.com (Wayne)
Date: Thu, 23 Jun 2011 01:02:29 -0400
References: <A6D581F79D074FB5A782E6FBD9A08DFB@EntCent><Pine.LNX.4.64.1106211052090.20352@thunder.banklogic.net><BANLkTinMzLNniAQbgq3U7FOS3ypm55OUVw@mail.gmail.com><CA97A6A330154554A4515EFF67EDC211@EntCent> <4E01B8B9.10704@xxiii.com> <2DBDCCA5AEF44465B363EBDAB5E637F2@EntCent>
On 6/23/2011 12:13 AM, Jack Brooks wrote:
> I don't turn rotors, I replace them when there is an issue.  No issues, I
> just roughen up the surface with coarse sandpaper, clean/lube the pins and

Yeah, rotors are too cheap these days to mess with turning.

I will highly recommend the Brembo OEM replacement rotors you can get 
from Tire Rack and elsewhere.  Really fantastic product:

* competitively priced.
* Super flat, minimal run out, apparently blanchard ground.  NOT the 
lathe turned concentric grooved finish cheap rotors have.
* factory balanced -- have clip on weights or drill outs to balance.
* NOT coated with oil or Cosmoline goop that requires a whole can of 
solvent + labor per rotor to remove
* don't seem to rust as badly on the non-swept surface as others.

-w

<Prev in Thread] Current Thread [Next in Thread>