On 6/23/2011 12:13 AM, Jack Brooks wrote:
> I don't turn rotors, I replace them when there is an issue. No issues, I
> just roughen up the surface with coarse sandpaper, clean/lube the pins and
Yeah, rotors are too cheap these days to mess with turning.
I will highly recommend the Brembo OEM replacement rotors you can get
from Tire Rack and elsewhere. Really fantastic product:
* competitively priced.
* Super flat, minimal run out, apparently blanchard ground. NOT the
lathe turned concentric grooved finish cheap rotors have.
* factory balanced -- have clip on weights or drill outs to balance.
* NOT coated with oil or Cosmoline goop that requires a whole can of
solvent + labor per rotor to remove
* don't seem to rust as badly on the non-swept surface as others.
-w
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|