Ok, I know I post alot of questions here. But I'd figure I'd post a few
of my solutions here as well.
A while back I was asking about the force applied to the tire changer from
Harbor Freight.
With the answers I got here, I made, what I consider, a rather elegant
solution to the mounting problem.
Again, I can't mount in my floor because of the radiant tubes. Also, I
don't want to put this thing in the middle of the floor anywhere.
So, I came up with way that the changer can 'fold' up to my table when not
in use, but quickly pulls out and with one nut, tightens super sturdy!
Here is a link to my instrucable on it...
<
http://www.instructables.com/id/How-to-mount-a-tire-changer-without-bolting-to-the/
>
Funny side note, now that I posted this and I'm sure others can use the
idea, Harbor Freight no longer offerers that changer on their site! DOH!!!
Moose
"Be as beneficent as the sun or the sea, but if your rights as a rational
being are trenched on, die on the first inch of your territory." Ralph
Waldo Emerson
|