Roger Garnett wrote:
>
> thomas walter x5955 writes:
>
> > MEASURING CYLINDER BORE TAPER:
> >
> > Noticed a cylinder bore gauge -> 2"-6" range for $180.00
> > other ways to measure for taper and out of roundness?
>
> > Other thought was to use a set of telescopic gauges's, and then
> > use feeler gauges to check for any clearance.
>
> T-Guages will work- you can them use a dial/digital caliper or mics to measure
> the T-guage. Certainly harder, and more prone to error than a direct reading
> bore guage, but a whole bunch cheaper too.
Just keep looking for the Rutland sales catalogs. About every other
catalog they have the bore gages on sale for under $100, usually
about $75.
>
> ________
> /___ _ \ Roger Garnett (Roger-Garnett@cornell.edu)
> /| || \ \ Agricultural Economics | The Wayward Sports Car Centre
> | |___|| _ | 3 Warren Hall | http://www.wayward.team.net/
> | | \ | | | Cornell University |
> \| \ |__/ / Ithaca, N.Y. 14853-7801 | (607) 533-7735
> \________/ (607) 255-2522 | Safety Fast!
jack
--
poller@netscape.com
|