thomas walter x5955 writes:
> MEASURING CYLINDER BORE TAPER:
>
> Noticed a cylinder bore gauge -> 2"-6" range for $180.00
> other ways to measure for taper and out of roundness?
> Other thought was to use a set of telescopic gauges's, and then
> use feeler gauges to check for any clearance.
T-Guages will work- you can them use a dial/digital caliper or mics to measure
the T-guage. Certainly harder, and more prone to error than a direct reading
bore guage, but a whole bunch cheaper too.
________
/___ _ \ Roger Garnett (Roger-Garnett@cornell.edu)
/| || \ \ Agricultural Economics | The Wayward Sports Car Centre
| |___|| _ | 3 Warren Hall | http://www.wayward.team.net/
| | \ | | | Cornell University |
\| \ |__/ / Ithaca, N.Y. 14853-7801 | (607) 533-7735
\________/ (607) 255-2522 | Safety Fast!
|