Well,
Please look here:
http://www.wsu.edu/~rsain/dingspots.jpg
In this pic (not of my cab - but another list member's) I put some green
dots where I have a few small radial type dents. Given that all these spots
have a piece of sheet metal covering them on the opposite side of the cab -
how the %$^# am I supposed to hammer them out? Or do I?
Should I just cut a little section out of the metal on the inside so I have
access then hammer away? Or should I simply fill em and forget em?
None are bigger than .75" in diameter. The truck is a 59
TIA,
- Ryan
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|
