Not sure that's correct -- might be for a TF 235. I used the stock plate
that was in my 50 to bolt in the newer 235/261 -- no mods needed.
Allen in Seattle
'50 3100
----- Original Message -----
From: "Rob" <a70ragtop@hotmail.com>
To: "_Oletrucks" <oletrucks@autox.team.net>
Sent: Friday, March 22, 2002 8:33 AM
Subject: [oletrucks] AD front motor mount question
> When putting a later model Task Force 235 into an Advance Design truck, I
know
> you need to modify the front cover plate to allow the use of the front
motor
> mount that the AD's used which involves drilling a couple of holes in the
> lower lip...correct? (TF's used the side mounts at the front I believe)?
If
> so, is there a pattern or template or measurements I can use to figure out
> where to put the holes so that after the engine is built, it will be ready
to
> drop in an have everything align properly? Can anyone help me out?
>
> Rob
>
> My Zen Moment for the Day: Duct tape is like the "Force." It has a light
> side and a dark side, and it holds the universe together.
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|