I went to PickNPull the other day and pulled a Power Brake setup off a '68
or
'69 Chevy 1/2ton PU. Coming off the Master Cylinder is the proportioning
valve, on the bottom of the proportioning valve goes the two brake lines for
the front and rear, but also in between these two lines is another fitting,
looks kinda like a barbed fitting, that wasn't connected to anything, and I'm
wondering what goes there? It's possible that something else went over this
fitting and all that is left is what I see, but I need to know what it's for
so
I can hook this up properly, I'm converting my '59 chevy PU to power brakes.
Thanks,
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|