oletrucks
[Top] [All Lists]

Re: [oletrucks] Hmmn, power brake Master Cylinder setup question

To: <oletrucks@autox.team.net>
Subject: Re: [oletrucks] Hmmn, power brake Master Cylinder setup question
From: "Claude Ramey" <cramey@n-link.com>
Date: Tue, 26 Oct 1999 16:53:06 -0500
If I remember.... There is a brake light warning switch. If the back or
front brakes lost pressure (leak?) this switch operated a dash light.
maybe, been a long time.
----- Original Message -----
From: <Passnb4U@aol.com>
To: <oletrucks@autox.team.net>
Sent: Tuesday, October 26, 1999 4:12 PM
Subject: [oletrucks] Hmmn, power brake Master Cylinder setup question


>   I went to PickNPull the other day and pulled a Power Brake setup off a
'68
> or
> '69 Chevy 1/2ton PU.  Coming off the Master Cylinder is the proportioning
> valve, on the bottom of the proportioning valve goes the two brake lines
for
> the front and rear, but also in between these two lines is another
fitting,
> looks kinda like a barbed fitting, that wasn't connected to anything, and
I'm
> wondering what goes there?  It's possible that something else went over
this
> fitting and all that is left is what I see, but I need to know what it's
for
> so
> I can hook this up properly, I'm converting my '59 chevy PU to power
brakes.
>
>   Thanks,
>
>   Mike
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>


oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>