In a message dated 4/27/99 10:49:29 AM Pacific Daylight Time,
tburt@hirose.com writes:
<<
> I have carb problems! The 350 in my '59 3/4 ton came out of an '86
> El Camino. It hasn't been running right for a week or so. I thought I
> had water in the distributor or had a vacuum leak, but this morning I
> discovered it is pumping gas out from around a rod on the top of the
> carb.
> I don't like these newer carbs anyway, to much junk on them. Does
> anyone know what older (meaning simple; manual choke, two adjuster
> screws. The basics.) carb will fit on this manifold? If so how about
> a good place to buy a rebuilt one? This is just an old work truck, I'm
> not trying to make it a hot rod and I don't care if I have to fine tune
> it once a week, but I want one that I can fine tune.
> Any info will help a lot since I'm not really up on carbs. It has
> been a long time since I had an older car, my last was a '70 Camaro.
> It seems I've forgotten much, yet I never knew a whole lot to start
> with. All I know is that the carb on that 350 didn't have half the
> compontents this one does.
>
> Thanks,
> Wayne '59 3/4 ton Apache
>
>
> >>
Wayne,
If you do decide to go with the Edelbrock series, check out Jeg's or Summit
for mail order pricing, should be less than $200.00.
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|