In a message dated 4/5/99 1:25:44 PM Pacific Daylight Time,
dillo021@tc.umn.edu writes:
<<
Did you bleed the master cyclinder? Most likely it air in the lines, try
bleeding the shortest length of tue first (this is usually the drivers
front wheel) then move to the 2nd longest and so on. Sometimes bleeding a
fresh system will take a while be patient, also make sure all you new
connections are tight. Good Luck. >>
This is backwards, start at the point furthest from the master cylinder.
Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|