Craig,
Yes you have it figured out. The end goes through the hole for the
cotter key on the accelerator rod. I have a cable stop (barrel nut) on
it but looping it around might work too. I also squeezed a small cotter
pin in the hole because past experience has taught me not to trust those
barrel nuts too far.
John '51 1/2 Ton
Minnesota
craig k wrote:
> While I know it goes through the little holder on top of my Rochester,
> WHERE does the business end connect?
> Should it go on the throttle lever, where the arm from the accellerator
> crank gets hooked up? Is there a special barrel nut, or should it just be
> looped thru the hole the cotter pin now sits in - etc etc.
>
>
> craig
> caretaker of
> stephanie's 50 3104 216 5-window deluxe
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|