mgs
[Top] [All Lists]

Re: [Mgs] 1967 O/D driveshaft

To: paul.hunt1@blueyonder.co.uk, roger@rogerlos.com, mgs@autox.team.net
Subject: Re: [Mgs] 1967 O/D driveshaft
From: wspohn4@aol.com
Date: Mon, 21 Dec 2009 11:32:45 EST
Be hard NOT to balance it as you are turning it up on a lathe, Paul, but  
its a fair point.
 
Bill
 
 
In a message dated 12/21/2009 8:22:13 A.M. Pacific Standard Time,  
paul.hunt1@blueyonder.co.uk writes:

Balanced  ...

----- Original Message ----- 

> Of course you can, but  because the OD trans is shorter, you need to have 
a
> 1 1/8" spacer  block machined up to go between the diff and rear 
driveshaft
> flange.  

_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>