The sliding joint is there to take account of positioning tolerances in the
mounting of engine and rear axle, as well as their relative movement when
driving. If you have a banjo axle then the difference is 1.125", whereas if
you have Salisbury it is 'only' 0.875. If you measure the fitted length of
your propshaft (axle hanging on its straps as this extends the shaft), and
compare that to the fully compressed length and the maximum expanded length
without the splines starting to disengage, you will have a better idea of
how feasible reuse will be. The biggest problem would be if it bottomed,
but that isn't going to occur with a non-OD shaft in an OD application as it
is the OD application that needs the longer shaft. If it pulls out too far
then the splines will start to disengage, which will increase the stresses
on what remains in engagement. FWIW on a V8 shaft from being fully
compressed there is 2" of movement available before the splines even start
to disengage, and 2 1/4" of male spline on the shaft itself. It has a fully
compressed length of 29.75", and a fitted length of 31.25". The result is
there is just over an inch of movement either way from a notional perfect
central point without the risk of either bottoming or the splines starting
to disengage. If your fitted length is more than an inch longer than the
theoretical 30" for a non-OD banjo or 31.125" for a non-OD Salisbury then
it's maybe not such a good idea to use it.
PaulH.
----- Original Message -----
> Can I really not use the driveshaft from my non O/D 5-main, 3-syncro
> gearbox
> when I do the O/D conversion?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|