I found the 1/4 inch 90 degree elbow in the plumbing department of a local
hardware store but I also got some impossible to find brass fuel line
fittings for my Healey project from Hemphill's Healey Haven (410-788-2291).
You might try calling them if you can't find what you need locally.
Ron
----- Original Message -----
From: "Bob Howard" <mgbob@juno.com>
To: <tburgin1@cox.net>
Cc: <mgs@autox.team.net>
Sent: Sunday, October 29, 2006 3:29 AM
Subject: Re: Fuel Line
> Tom,
> The SU pump pressure is 3-4 psi. More than that often overpowers the
> carb's needle valve. If you are using a pump other than an SU, a
> pressure regulator may be needed.
> Sorry, I don't know a source for the OEM fuel line parts other than
> Moss, Curto, etc. You might look in your local hardware store though, as
> some have amazing inventories of little brass fittings.
> Bob
>
> On Sat, 28 Oct 2006 22:23:58 -0500 "Thomas L. Burgin" <tburgin1@cox.net>
> writes:
>> I am putting two SU HS4 carbs in my 1980 MGB. I would like to make
>> up new fuel lines. I have not been able to find 1/4 by 1/4 inch
>> elbow for the fuel line. Does any one have a source. Is there any
>>
>> pressure requirement for the SU carbs? I now have the electrical
>> pump that supplies fuel to the Zenith.
|