Tom,
The SU pump pressure is 3-4 psi. More than that often overpowers the
carb's needle valve. If you are using a pump other than an SU, a
pressure regulator may be needed.
Sorry, I don't know a source for the OEM fuel line parts other than
Moss, Curto, etc. You might look in your local hardware store though, as
some have amazing inventories of little brass fittings.
Bob
On Sat, 28 Oct 2006 22:23:58 -0500 "Thomas L. Burgin" <tburgin1@cox.net>
writes:
> I am putting two SU HS4 carbs in my 1980 MGB. I would like to make
> up new fuel lines. I have not been able to find 1/4 by 1/4 inch
> elbow for the fuel line. Does any one have a source. Is there any
>
> pressure requirement for the SU carbs? I now have the electrical
> pump that supplies fuel to the Zenith.
>
> Thomas L. Burgin
|