Thanks Zach, sounds like a good plan. At the very least I may be able to
drill the screw out from below.
Richard Gosling
Senior Engineer
Operations - Engineering
Atkins
6 Golden Square, Aberdeen AB10 1RD
Tel: 01224 619487
Fax: 01224 647652
E-mail: richard.gosling@atkinsglobal.com
www.atkinsglobal.com
_____
From: Zach Dorsch [mailto:herr_dorsch@yahoo.com]
Sent: 07 December 2005 15:30
To: Gosling, Richard B; mgs@autox.team.net
Subject: RE: Poor brakes - and how to get to them
I know that space is tight under the dash, but that may be another option.
Use a set of vice grips (mole grips?) to get the machine screw from under
the dash next to the pedal. I can't look right now, but I remember that on
my '73 they stuck down far enough to at least give it a try.
Hope this helps,
Zach
"Gosling, Richard B" <Richard.Gosling@atkinsglobal.com> wrote:
Thanks for the input Robert.
I don't own a Dremel - I'd be happy to buy one (always happy to have an
excuse to enlarge my tool collection!), but I really doubt that it would be
able to fit in to that! narrow gap between the pedal box and the wing.
As for removing the wing, well, I've only just fitted it on! But again,
removing the outer wing wouldn't help, because the inner wing is still in
the way...
Richard Gosling & Nancy
_____
Yahoo! Personals
Single? There's someone we'd like you to meet.
Lots of someones, actually. Try Yahoo!
<http://us.rd.yahoo.com/evt=36108/*http://personals.yahoo.com> Personals
This message has been scanned for viruses by
<http://bluepages.wsatkins.co.uk/?4318150> MailControl
This email and any attached files are confidential and copyright protected. If
you are not the addressee, any dissemination of this communication is strictly
prohibited. Unless otherwise expressly agreed in writing, nothing stated in
this communication shall be legally binding.
|