Yes, i did make a mark on the distributor and the clamp, but not on the clamp
and the block. I removed the clamp to clean the dirt and rust off without
realizing the mounting holes were elongated, so I suppose I could be quite a
few
degrees out. Guess I'll have to go back to square one and find TDC, etc.
donny v
1978 MGB
In a message dated 4/12/2004 1:43:45 AM Eastern Standard Time,
mvheim@studiolimage.com writes:
Hint for future situations -- before removing distributor, scribe matching
lines on the distributor base and the clamp or block (actually both are
necessary on the B). At least you will be able to pick up where you left
off.
|