John,
Some cut holes with holesaw so that the socket wrench can get onto
these two bolts. I haven't done that, but have strugged for hours to get
these two turned tight. Since the area is filled with dirt and grit, I
used squirt bottles of paint thinner and WD40 to rinse the grit out of
the threads. Not a pleasant job.
Bob
On Sat, 14 Feb 2004 08:50:04 EST Jethogger@aol.com writes:
> Hello All. Does anyone know a simple way to remove the OD Tranny
> rubber mounts. There are four 5/16 short bolts that hold the cross
member
> to the tranny.
> Two can be remove with a suable socket. But the other two are a bear
> to remove. And ever hard to reinstall. I have install many tranny.
> But these over drives suck and take me a lot of time. To install two
of the bolts.
> Any tricks of the trade here. Thanks John, Flintstone, GA
|