Hello listers------------was under my '71B project cleaning the contacts on
the starter---hoping to find out why the starter will not spin and I noticed
the or a DPO installed a new slave cylinder and did not (as usual I
understand) remove the bleed screw and replace it to the side but put the
hydrolic line in the bleed hole etc----------my question to correct this, how
much fluid will I lose-----will it be only a few drops-----or will I lose
most of the fluid?-------------not a big deal either way just thinking do I
need a rag to catch the spill or a pan?------my clutch has always engaged
near the foor------I hope this will help the clutch action---------thanks
again Apple
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|