I think you are correct. If I remember correctly, there is a difference in
addition to the bore size. There is a pin on the backside of the cylinder
that fits into to a hole on the backplate. These are at different locations
on the roadster than on the GT (so you have to modify the location of the hole
to match the cylinder if you use a gt cylinder on a roadster brake system). I
am doing this from memory so you need to check it out, but you should be able
to place a hole in the appropriate place to match the cylinder you plan to
use.
Bill
'74 BGT
On Fri, 28 Jun 2002 08:48:17 -0600 Larry Hoy <larryhoy@marketvalue.net> wrote:
I would like to verify something.
If the rear brake cylinders on a roadster are replaced with the larger
bore brake cylinders from the GT ........
Larry Hoy
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|