Took the engine out again and the clutch was installed correctly. Found
that the fork/throwout bearing
were binding on the shaft from the gearbox. It had a lot slop and after
putting the rebuild kit in the slave, tightening up everything we were able
to center the shaft through the bearing. Don't know if this is what caused
the problem, but it seems to be working now. Will know for sure after
finishing up with reinstall on engine and rebuild on master, but it looks
promising.
THANKS!
Mike R
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|