My DPO replaced the bushings and washers in my pedal box with hose
clamps. Nothing lined up correctly. I replaced all the little bits
and pieces and it all worked with minor adjustment. Make sure you have
the right bits inside the pedal box. (I.E. Not hose clamps! :)
On Sun, 13 Jan 2002 14:47:52 -0500, Duinhoven_Hans@emc.com wrote:
>On the brake pedal box there is the brake light switch.
>Make the wires short circuit in order to see the switch is operating well.
>Have the ignition ON while doing this. For prolongued troubleshooting this
>way it's better to remove one of the low tension wires of the ignition coil
>in order to prevent damage of the coil by continuous current.
>If the lights illuminate, the brake switch maybe faulty.
>If not - check the grounds from the rear lights. These can be corroded.
>The switch is actuated by the brake pedal and might need some cleaning.
>Also take care of cleaning all connectors in the circuit.
>When reassembling the switch, it's important to have it adjusted correctly.
>
--
Andrew Lundgren
lundgren@byu.net
http://lundgren.denver.co.us
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|