No experience with an MGA but have you tried alternately tightening and
loosening?
----- Original Message -----
From: Edwin McCarroll <emccarroll@mco.edu>
To: <Mgs@autox.team.net>
Sent: Thursday, August 17, 2000 6:46 PM
Subject: MGA Temp. Sender Unit
> Been trying to remove the water temperature sending unit located at the
front side of the engine block. I would like to remove the unit and test
the temp gauge against a thermometer for correct readings, however all my
efforts so far have only succeeded in starting to round off the 'nut' (can
only get an open end wrench on it because of the transmitter line) . Other
than application of penetrating liquid, does anyone have any additional
suggestions to get around this problem? Thanks for any help.
>
|