On Mon, 7 Aug 2000 19:20:52 -0500 Bob Shaw <shaws@mlcltd.com> writes:
>
> > Have
> >the MGA rear plate bored out to accept the MGB rear crankshaft
> seal. You
> >need an adapter bushing for the rear end of the crankshaft to
> accept the
> >(smaller) pilot nose of the MGA gearbox input shaft.
>
> Moss carries it, but I can't recall the number
And you won't find it in the MGA catalog. It is in the MGB catalog and
described as a "3 main to 5 main conversion bushing" or some such. Check
www.mgamgb.com for the actual part number.
David Littlefield
Houston, TX
'62 MGA MkII
'51 MGTD
'88 Jaguar XJ-S
________________________________________________________________
http://dl.www.juno.com/get/tagj.
|