Just out of interest, does it hurt to be filled more than half, or does it
just get messy?
At 10:24 AM 7/26/00 -0700, Garner, Joseph P. wrote:
>Yep, the expansion tank is only meant to be half full.
>
>cheers
>
>joe
>
>_________________
>
>Dr. Joseph Garner
>Department of Animal Science,
>University of California,
>One Shields Avenue,
>Davis,
>CA 95616
>USA
>
>tel: + 530 754 5291
>fax: + 530 752 0175
>_________________
>
>
>
> > -----Original Message-----
> > From: wcameyer [mailto:wcameyer@email.msn.com]
> > Sent: Wednesday, July 26, 2000 10:08 AM
> > To: Mike Razor; mgs@autox.team.net
> > Subject: Re: New Question, MGB Raditor
> >
> >
> > Actually, the rubber grommet does work pretty well, but after
> > losing it
> > while trying to remove the plug so I could short across it
> > and get the fans
> > to run, I decided to wire it down with tie wire! Feel much
> > better now!
> >
> > Bill
> > ----- Original Message -----
> > From: "Mike Razor" <mrazor@mis.net>
> > To: <mgs@autox.team.net>
> > Sent: Tuesday, July 25, 2000 6:42 PM
> > Subject: New Question, MGB Raditor
> >
> >
> > > Car was running hot and I popped the hood and touched the little
> > > sensor unit that goes into the top tank on the radiator. It popped
> > > out and fluid spewed forth, until I stuck it back in. It has black
> > > goop holding it in. I drove the car home, it ran good and cool, the
> > > little sensor worked and did not come out know and the fans
> > kick on as
> > > they should. What gives with the gizmo popping out, is
> > there a bracket
> > > that holds it in?
> > > Next question. The tank that has the filler cap on it was
> > about half
> > > full, I did not fill it all the way up, thinking that it is
> > only half
> > > full in anticipation of overflow, is that tank suppose to
> > be only half
> > > full?
> > > THANKS!
> > > MIKE R
> > >
> >
> >
|