Yep, the expansion tank is only meant to be half full.
cheers
joe
_________________
Dr. Joseph Garner
Department of Animal Science,
University of California,
One Shields Avenue,
Davis,
CA 95616
USA
tel: + 530 754 5291
fax: + 530 752 0175
_________________
> -----Original Message-----
> From: wcameyer [mailto:wcameyer@email.msn.com]
> Sent: Wednesday, July 26, 2000 10:08 AM
> To: Mike Razor; mgs@autox.team.net
> Subject: Re: New Question, MGB Raditor
>
>
> Actually, the rubber grommet does work pretty well, but after
> losing it
> while trying to remove the plug so I could short across it
> and get the fans
> to run, I decided to wire it down with tie wire! Feel much
> better now!
>
> Bill
> ----- Original Message -----
> From: "Mike Razor" <mrazor@mis.net>
> To: <mgs@autox.team.net>
> Sent: Tuesday, July 25, 2000 6:42 PM
> Subject: New Question, MGB Raditor
>
>
> > Car was running hot and I popped the hood and touched the little
> > sensor unit that goes into the top tank on the radiator. It popped
> > out and fluid spewed forth, until I stuck it back in. It has black
> > goop holding it in. I drove the car home, it ran good and cool, the
> > little sensor worked and did not come out know and the fans
> kick on as
> > they should. What gives with the gizmo popping out, is
> there a bracket
> > that holds it in?
> > Next question. The tank that has the filler cap on it was
> about half
> > full, I did not fill it all the way up, thinking that it is
> only half
> > full in anticipation of overflow, is that tank suppose to
> be only half
> > full?
> > THANKS!
> > MIKE R
> >
>
>
|