You need to be able to hold it from spinning, Haynes has a picture of how
to do it. Basically put a piece of strap steel on to one or two of the
drive shaft bolts and let the other end press against the ground in the
opposit direction from how you want to remove the nut. An air impact
wrench will also do it easily.
...Art
On Wed, 8 Mar 2000 runriver@carolina.net wrote:
> I need to remove to flange on the end of my 75's trans. I need to do
> this to replace one of the 4 bolts that attach it to the drive shaft .
> Is there anything special I need to do to remove & put back on the large
> nut holding the flange on?
> Any help would be appreciated.
> Charlie, NC
> PS- Thanks to everyone who posted info on electronic ignition
> conversion.
>
>
|