You will probably need to fabricate a strut to bolt onto the flange at two
points that will brace itself against the car or the floor (you will
obviously be supporting the car very securely) as you loosen and tighten the
nut. In your case I would suggest only pulling forward enough to get the
new bolt in rather than pulling it all the way out.
PaulH.
----- Original Message -----
From: <runriver@carolina.net>
To: <mgs@autox.team.net>
Sent: Wednesday, March 08, 2000 5:12 AM
Subject: Newbie-Trans Flange
> I need to remove to flange on the end of my 75's trans. I need to do
> this to replace one of the 4 bolts that attach it to the drive shaft .
> Is there anything special I need to do to remove & put back on the large
> nut holding the flange on?
> Any help would be appreciated.
> Charlie, NC
> PS- Thanks to everyone who posted info on electronic ignition
> conversion.
>
>
|