mgs
[Top] [All Lists]

Re: Battery Size information needed-re cutoff switch

To: "MGs" <mgs@autox.team.net>
Subject: Re: Battery Size information needed-re cutoff switch
From: Max Heim <mvheim@studiolimage.com>
Date: Thu, 10 Feb 2000 16:41:00 -0800
So, when did they start putting cigar lighters into MGs? My guess is 
1968... am I right? I know a '66 has no such thing.

Bud Krueger had this to say:

>FYI,  NAPA sells a setup that does that very thing.  It's a 9v battery 
>connector
>wired to a cigarette lighter plug.  You might recall that the cigarette 
>lighter
>circuit is active at all times, as is the lead to a radio that is intended 
>to hold
>the presets.  The primary intent of the gadget is to maintain the car's 
>computer
>programming when the battery is disconnected during service.  In this case it
>doesn't matter which side of the battery is disconnected (or both).
>
>Chris Kotting wrote:
>
>> Two things:
>>
>> Not disputing the point, but I was always told to put the switch on the
>> ground side.  What is the reason for sayng it should be on the
>> non-ground?
>>
>> A good way to keep the radio presets from going away is to wire a VERY
>> low value fast-acting in-line fuse across the switch.  You open the
>> switch, and power is available to keep the presets alive through the
>> fuse.  Anything starts drawing real power (even a dome light bulb, if
>> you put in a low enough value fuse) and the fuse blows and the circuit
>> is open.  Another way is to have a 9 volt battery wired to a cigarette
>> lighter plug.  Plug that in to the cigarette lighter just before
>> throwing the switch.  9 volts is enough to keep the presets alive.
>>
>> Chris Kotting
>> ckotting@iwaynet.net
>>
>
>--
>Bud Krueger
>http://home.ici.net/~bkrueger/
>52TD
>77MGB
>
>
>


--

===============================
Max Heim
mvheim@studiolimage.com
Studio L'Image/San Francisco
415 643 9309 : 415 643 9307 fax
Studio L'Image/New York
212 242 3366 : 212 242 3399 fax


<Prev in Thread] Current Thread [Next in Thread>