..... and the seal at the top of the tube is often on wrong or is bad where
the casting is mis-shapen and held together with the wrong screw. Other
than that..........
----
At 06:17 PM 11/15/1999 , Harlan Jillson wrote:
>Just a note on the uni-syn,
> Some of them are being manufactured in china lately ( big suprise), and
>may or may not work correctly. The problem appears to be in the seal
>between the face plate that seals to the front of the carb. intake and the
>tube with the little red ball in it. It seems that some of the castings are
>particularly good and leaks in this area cause either poor or no response as
>it can't hold low pressure from the air flow. It is repairable if you take
>off the sealing face and clean up the casting and use a little sealer, but
>it's a pain in the arse on a unit you just bought.
> Guess how I found this out.....
>Harlan.
>
|