>
> > Earlier I had posted a question about using the V8 A-Arm bushings and the
> > general consensus seemed to be that it was a good move. However, one
> > lister (Hal Rogers?) suggested that the bushings needed to be pressed in.
> > I don't doubt this is the wise choice, but wonder if they can be pulled
> > into place using a bolt and washers
>
> Yes.
>
> > or can it be done in a bench vise,
>
> Yes
>
> > or can I just smack 'em into place with a hammer and large socket?
>
> Hmm, use the sockets and a large vise.
>
> Larry Hoy, Denver, CO. USA
Larry's is right although I might add that if you used a little Windex
to slick it up, they will slide right in.
Larry Dickstein
Lone Jack, MO
Bob Allen's slow computer student!!!
|