Earlier I had posted a question about using the V8 A-Arm bushings and the
general consensus seemed to be that it was a good move. However, one
lister (Hal Rogers?) suggested that the bushings needed to be pressed in.
I don't doubt this is the wise choice, but wonder if they can be pulled
into place using a bolt and washers, or can it be done in a bench vise,
or can I just smack 'em into place with a hammer and large socket?
Rich
Council Bluffs, Iowa, USA
'74.5 RB MGB "Miss Maggie"
'78 Chevy Half-Ton "Waltzin' Matilda" (LBC Support Vehicle)
'79 Midget "Miss Molly"
richard.arnold@juno.com or rdarnold@neonramp.com
|