> Earlier I had posted a question about using the V8 A-Arm bushings and the
> general consensus seemed to be that it was a good move. However, one
> lister (Hal Rogers?) suggested that the bushings needed to be pressed in.
> I don't doubt this is the wise choice, but wonder if they can be pulled
> into place using a bolt and washers
Yes.
> or can it be done in a bench vise,
Yes
> or can I just smack 'em into place with a hammer and large socket?
Hmm, use the sockets and a large vise.
Larry Hoy, Denver, CO. USA
1967 MGB Roadster, Vintage Racer
1969 MGB Roadster, Driver
1970 MGB Roadster, Fixer upper
http://home.cwix.com/~larryhoy@cwix.com
|