Gene, the OEM tonneau cover goes over the bar and snaps onto the two
fasteners at the lower edge of the seat back.
Bud Krueger
Gene Fodor wrote:
> Good Day Listers . on the TD's seat back, there is a bar that runs the width
> of the back. It is attached to the back by 4 screws - 2 on each side of the
> bar.
>
> It does seem to have any specific purpose as the tilt of the back is
> adjusted by another assembly located immediately below the bar.
>
> This is kind of a trivial question, but does anyone know it purpose?
>
> Tks
>
> Cheers
>
> Gene
>
> Vermont
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Mg-t@autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|