Hi Gene,
I don't know a lot about the TD, but I'd guess it's the tonneau bar.
The TF has two tonneau bars, since it has two bucket seats. They keep the
tonneau snug against the seat, and prevent the full tonneau from flapping in
the wind.
-Mike Eldred
Wilmington, VT
'54 MG TF
'73 Midget
'51 Willys M38
> From: crownwheel@surfglobal.net
> To: mg-t@autox.team.net
> Date: Tue, 10 Nov 2009 10:48:13 -0500
> Subject: [Mg-t] Question
>
> Good Day Listers . on the TD's seat back, there is a bar that runs the
width
> of the back. It is attached to the back by 4 screws - 2 on each side of the
> bar.
>
> It does seem to have any specific purpose as the tilt of the back is
> adjusted by another assembly located immediately below the bar.
>
> This is kind of a trivial question, but does anyone know it purpose?
>
> Tks
>
> Cheers
>
> Gene
>
> Vermont
>
_________________________________________________________________
Hotmail: Trusted email with Microsoft's powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141664/direct/01/
http://clk.atdmt.com/GBL/go/177141664/direct/01/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|