I believe the original tonneau was only a half-tonneau, and the bar was
meant to hold it taut.
Sarah Carr
TD3942EXLU in PA
----- Original Message -----
From: "Gene Fodor" <crownwheel@surfglobal.net>
To: <mg-t@autox.team.net>
Sent: Tuesday, November 10, 2009 10:48 AM
Subject: [Mg-t] Question
> Good Day Listers . on the TD's seat back, there is a bar that runs the
> width
> of the back. It is attached to the back by 4 screws - 2 on each side of
> the
> bar.
>
> It does seem to have any specific purpose as the tilt of the back is
> adjusted by another assembly located immediately below the bar.
>
> This is kind of a trivial question, but does anyone know it purpose?
>
> Tks
>
> Cheers
>
> Gene
>
> Vermont
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Mg-t@autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|