Bob, Dave and all,
Thanks for the info. I am very uncomfortable with the Wood "XPAG Engine"
values. Took the 10mm to 35 lbs and the 8mm to 25.
While I'm asking questions, does anyone know a source for 6 point
BSF/Whitworth sockets and combo wrenches? All my stuff is 12 point.
Thanks again,
Ed Woods
P.S. I'm still using the original type oil filter and was able to get one at
Advance Auto. Had to order it, but it took only a day.
EW
----- Original Message -----
From: "Bob Grunau" <grunau.garage@sympatico.ca>
To: "Dave and Liz DuBois" <ddubois@sinclair.net>; "Ed Woods"
<fogbro1@comcast.net>
Cc: "MG-T" <mg-t@autox.team.net>
Sent: Wednesday, July 08, 2009 2:01 PM
Subject: RE: [Mg-t] questions
> Dave and Ed,
> Dave, in general I agree with your torque table values, EXCEPT for the
> rocker stand bolts. I like to use 25 ft-lbs ( you show 19 ft-lbs ) for
> the
> 8 mm bolts and 35 ft-lbs ( you show 43 ft-lbs ) for the 10 mm bolts. I
> have
> broken 10 mm bolts trying to use 43 ft-lbs . I know Woody Woods in the
> XPAG
> Engine book shows 29 ft-lbs for 8 mm and 43 ft-lbs for 10 mm but I feel
> these numbers are too high.
> Bob Grunau
> Canada
>
> -----Original Message-----
> From: mg-t-bounces@autox.team.net [mailto:mg-t-bounces@autox.team.net]On
> Behalf Of Dave and Liz DuBois
> Sent: Wednesday, July 08, 2009 12:38 PM
> To: Ed Woods
> Cc: MG-T
> Subject: Re: [Mg-t] questions
>
>
> Ed,
>
> For information on torque for various fasteners in the XPAG/XPEG engines
> see the list, Torque Values for TD and TF Fasteners in the Other Tech
> Articles on my web site at: http://homepages.donobi.net/sufuelpumps/
>
> Cheers,
> Dave
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Mg-t@autox.team.net
> http://autox.team.net/mailman/listinfo/mg-t
>
> Archives at http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t
Archives at http://www.team.net/archive
|